close
close

How Do You Light Pilot Light On Gas Fireplace

How Do You Light Pilot Light On Gas Fireplace

How Do You Light Pilot Light On Gas Fireplace. Second step in how to light it is, turn the gas/pilot valve to the pilot position.you must then hold down this knob while simultaneously pressing in the igniter button (this may take several tries. Press the button to verify that theres a spark at the end of the pilot tube.

How Do You Light Pilot Light On Gas FireplaceHow Do You Light Pilot Light On Gas Fireplace
Gas Log Gas Log Pilot Light Won''t Light from gasloggakazaru.blogspot.com

If the fireplace’s ignitor still doesn’t ignite, replace the vent cap. If the pilot doesn’t light, wait 10. Press the sparker or use a match to ignite the pilot light.

Turn The Gas Control Until The “Pilot” Setting Aligns With The Mark On The Outer Rim Of The Control.

Turn off the gas and fire switch. If the pilot does not light within 45 seconds,. View the step by step guide to safely light the pilot light on your heatilator gas hearth.

Evacuate The Air And Try Lighting The Pilot Light.

To start the blaze, press your finger into the center of the control knob and hold it in place. Second step in how to light it is, turn the gas/pilot valve to the pilot position.you must then hold down this knob while simultaneously pressing in the igniter button (this may take several tries. Remove the access cover to the controls.

Push The Button In While You Push The Starter.

What does pilot mean on fireplace? Make sure the gas shutoff valve is turned off and wait five minutes to remove any excess gas. Open the access panel on the bottom front of the fireplace to light a superior gas fireplace.

READ this  How To Turn Off Pilot Light On Superior Gas Fireplace

The Pilot Is Where The Gas Comes Out And Provides The Small Flame Used To Light The Main Burner Flames (The Main Flames Seen In A Gas Fireplace).

Based on the average cost of natural gas, this comes out to about $7 to $10 per month. You turn the control knob to. If the fireplace’s ignitor still doesn’t ignite, replace the vent cap.

Turn Gas Control Unit The Pilot Setting Aligns With The.

Adjust the propane regulator lever till the “pilot” position matches the arrowhead or cross point on the controller’s outside rim. To begin, turn the knob to the left and press it in. How does the gas fireplace pilot light work?

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *